外围体育投注

Press J to jump to the feed. Press question mark to learn the rest of the keyboard shortcuts

AnycubicMegaS

r/AnycubicMegaS

1
Posted by6 hours ago
Post image
1
3 comments
1
Posted by1 day ago

外围体育投注Hi, what firmware are you guys running on your printers? Im still working with the pre installed one (V1.1.2), but I'm think about to upgrade it to Marlin. I would be happy to hear your experience and get some recommendations.

1
4 comments
3
Posted by6 days ago
Post image
3
9 comments
2
Posted by7 days ago
Post image
2
12 comments
2
Posted by11 days ago

外围体育投注I cannot pull out my Boden tube I tried pushing on the black disk but it won't come out

2
4 comments
1
Crossposted by12 days ago
Posted by12 days ago
1/3
5 points
1
1 comment
3
Posted by18 days ago

Hi so I have the Anycubic mega s and I’ve had it for awhile now. I’ve only used the pla with the printer but I want to start using wood material as well. Anycubic website doesn’t sell them but it says that the printer can use wood filaments. What is the best roll to get and what setting should I change to have the best print with it

3
4 comments
2
Posted by19 days ago

外围体育投注So I replaced my Hotend+ Bowden tune on my printer just the other day and tried out a print. Filament extruded fine at first (though it did come out somewhate "cocked" before straightening out) but when it came time to do the actual print the filament wouldn't extrude at all and turned out to have gotten jammed in the hotend. Used standard filament feed temprature (230 I think) then attempted print at 195. Printing with Esun Black PLA. Follow up issue is a wierd one; I get the bed levelled to my liking but then when I go to print i notice the nozzle is printing about 1mm above the home position for the Z axis. Not sure what the heck is going on here and would appreciate some help

2
0 comments

About Community

This is the official Subreddit for the Anycubic Mega-S which was just released.
723

Members

5

Online


Created Dec 30, 2018